Programming Guide

Quiescent Draw: 15 mA
LED Draw: 150 mA maximum apiece
• Avoid connecting more than one LED to the controller when it’s
being powered by your computer.
Input Voltage: 6V recommended, 4-7.2v nominal
• Runs off BEC power; make sure your BEC can handle it!
LED Brightness: Up to 15 lumens
Maximum Controller Commands: 94
Interface: USB
Operating System: Windows 98, 2k, 2k3, NT, ME, XP, Vista
Dimensions:
DELight Controller: 28 x 22 x 5mm; 31cm pigtail; 6mm header; 6g
1.1” x .9” x .2”; 1’ pigtail; .25” header; .2 oz
LEDs: 10 x 5 x 3mm board; 61cm pigtail; 3g
.4” x .2” x .1” board; 2’ pigtail; .1 oz
General Description:
The DELight is a programmable lighting controller designed for some of the
greatest ease of use on the market. DELight supports eight channels of
LEDs. Channels 1-4 can output 250mA and can be configured for
brightness, timing, stick position, signal loss, hysteresis and more. Channels
5-6 can output up to 2 amps and can be programmed for all of those but
brightness, or make another auxiliary switch. Channels 7-8 can also output
2A; anything hooked in to them will be on as long as it has power, so they
make a good test of whether or not the DELight is receiving power and are
handy for navigation lights and night flying.