User Manual

Here is a table of typical max loads you can power with an AnyVolt Micro, depending on your
input voltage.
3.3V in
Output Voltage (V)
3 4 5 6 7 8 9 10 11 12 13 14
Max current out (mA)
413 310 248 207 177 155 137 124 113 103 96 89
5V in
Output Voltage (V)
3 4 5 6 7 8 9 10 11 12 13 14
Max current out (mA)
500 467 375 313 268 234 208 188 171 156 145 134
9V in
Output Voltage (V)
3 4 5 6 7 8 9 10 11 12 13 14
Max current out (mA)
500 500 500 500 442 422 375 338 309 281 260 241
12V in
Output Voltage (V)
3 4 5 6 7 8 9 10 11 12 13 14
Max current out (mA)
500 500 500 500 500 500 500 450 410 375 346 321
Overcurrent/overtemperature behavior
If the current limit has been considerably exceeded, or if the device is overheated to beyond 85ºC
the AnyVolt Micro will gradually reduce the output voltage in an attempt to reduce the load on the
device. Once the extra load is removed or the temperature is brought down, the desired output
voltage will be restored. It is unlikely that you will destroy an AnyVolt Micro by exceeding the
current/temperature ratings but we still recommend practicing good engineering techniques and do
not overload the device beyond the recommended operating parameters.
Additional notes
AnyVolt Micro uses a 25 turn worm gear driven potentiometer and cannot wiggle loose. Do not
apply glue to the voltage adjustment pot.
AnyVolt Micro should be mounted at least 2 inches away from any circuitry that is sensitive to RF.
For best performance, mount AnyVolt Micro in an open space with some air flowing across it to
keep it cool.