User Manual

Motor Terminals
Motor 1 is connected to terminals M1A and
M1B. If the motor runs in the opposite way
that you want, you may reverse the motor
wires to reverse rotation.
Motor 2 is connected to terminals M2A and
M2B as shown to the right.
Signal Input Terminals
S1 and S2
The input signals that control the Sabertooth
are connected to terminals S1 and S2. If you
are running in analog mode, it is important to
have both the signal wires connected before
applying power to the device. Otherwise, the
motors may start unexpectedly.
The motors connect to terminals M1A/B and
M2A/B
The input signals connect to terminal S1 and/or S2