User Manual

DEScribe Software:
The Sabertooth 2x60 motor controller can interface with our DEScribe software. This software
package will allow the end user to change a lot about how the controller behaves both on the
input and output sides.
Features:
• Modify the throttle curve map
• Adjust Ramp Time
• Adjust Dead Band
• Change analog voltage input center and range
• Change servo pulse timings in RC mode
o Perfect when a smaller or larger range is optimal
• Adjust timeout length in RC mode
• Set simple serial mode to use custom throttle curves
• Set baud rate with one drop-down box
All of these features can be programmed to a compatible motor controller via a USB link.
DEScribe also has the option to download the current setup from a connected driver back to the
software. There are options to save and open custom configurations within the software. This
software can also be used to batch program compatible drivers for custom setups.