Installation Guide

⑨
⑧
Pile tile as shown, flush pipe sediment.
Install the water control switch and install the waterfall outlet as
shown.
Installation is finished, test whether each function is used normally
, wipe clean bibcock surface with soft cloth.
depth1.97"-2.36"
4.72"
3.15"
3.15"
11.81"
6.26"
Water spouts
out of the
pipe
Hot water inlet pipe
Cold water inlet pipe
6.3"
11.81"
4.72"
Ø1.97"
According to the basic size of the embedded box, use
a special tool to cut the main hole on the solid wall
between 1.97" and 2.36" deep.
6.3"
First find a good stainless steel fixing bracket, with
crews locked in the embedded box up and down the
xtended position;Wall pre (main body size 3.15"X3.15",
outlet nozzle 6.3"X4.72").
As shown in the figure, pre-bury the intake water pipe
and pay attention to the preparation the upper and
lower left and right directions of the buried box, the
outlet is upward,connect hot water pipe on the left and
cold water pipe on the right.
Open the water source to test whether the left and right
inlet pipes are tightly connected without leakage. After
the inlet pipes are tested and closed, adjust the flow
switch to be in the open state to test whether the mixed
outlet pipes are tightly connected without leakage.Adjust
the horizontal position and fix it with the fixing bracket.
Make sure again that the pipe connection is correct
and there is no leakage in the water test. Seal and
fix the embedded box and pipe with packing. At this
point, the solid wall embedded box is installed and
the plastic protective cover is taken out.
As shown in the picture, prepare to paste ceramic tiles. Open
holes with a diameter of 1.97" on the right side and a gap of 4.92"
between the two holes.Rectangular slot on the left side, center
distance 11.81".