Installation Guide

12、Temperature setting
The actual conditions, will have a significant impact
on the temperature measured at the point of discharge.
In the event that the safety stop at 100°F does not
establish the precise temperature, follow the
instructions below
1.Remove the cover and loosen the allen screw.
2. Lower the temperature to 100°F position,
opening the check valve and verify the water
temperature using a thermometer.
3.Turn the thermostat knob and gradually raise
the temperature of 86ºF to 100ºF, pull the
plastic handle to the right and push it back
towards the center position of 100ºF.
4.Replace the screw, and then tighten the cap.
86
100
95
113
122
°F
OFF
13、Temperature Limitation
1.The safety stop limits the temperature range of
100ºF, by pressing the button on the thermostatic
handle, the temperature limit can be canceled and
get a higher temperature.
14、Operation
1.Adjust the temperature to the desired position by
adjusting the thermostat knob on the left side (or
down side) of the mixer valve as shown in detail
below.
2.Open the valve on the right side (or top side)of
the mixing valve, indicated in the detail below as
flow handle . The flow can be increased by fully
opening the valve, according to the instructions
below.
Diverter handle
Thermostatic bath
11/16 12/16