Installation Guide

Care and Maintainance
How to clean shower head nozzles
1. Just rub the nozzles with your finger or toothbrush to loosen any deposits, and then
run hot water for a few minutes.
2. Put the showerhead into a pot. Consider using a smaller container that just about fits the
shower head; this way, you will use less vinegar. You can also use a small bucket or plastic bin.
Fill the pot with enough white vinegar to cover the showerhead. The acids in thevinegar will help
dissolve the white mineral deposits on the showerhead.
Let the showerhead soak in the vinegar for 30 minutes. The more soiled the showerhead is, the
longer you will have to leave it the vinegar.
If the cartridge is worn out which cause leakage, please turn off the water source. Remove the handle,
panel, and decorative cover in sequence, remove the gland with a wrench, then take out the cartridge
and copper sleeve. Repair or replace the new cartridge, then install it again in sequence.
In order to keep the shower set appearance smooth and good performance, please follow the
below steps to clean and maintain it.
1、Clean with water and dry with a soft cotton cloth；
2、Use a mild liquid and a colorless glass cleaner to remove surface dirt and scale, also you can use the
cleaner without grinding function.
3、Do not use detergents, polishing tools, abrasive cloth, paper towels or scrapers to clean the product.
4、Do not use acid cleaners, insoluble granular detergents, soaps, etc to clean the product.
Customer Service Support:
If you have any concerns for this product, welcome to contact us
by email at [e-mail] or by phone call at 323 287 5697.