Installation Guide

8、The procedure of sealing the wall
o
ut
s
ide
t
h
e w
a
ll
wall
Tile surface
≥0.6"
Use a parallel ruler to measure the flatness of the embedded box casing and the vertical wall surface. If
the wall surface is not flat, it should be patched to ensure the embedded box casing and vertical wall
angle meets at nearly ideal angle of 90, then lay the tile decoration.
According to the figure below, please correctly adjust
the direction of water separator handle
Handle shower
outlet water
Top shower
outlet water
9、Installation of control valve
1、Take off the protective panel and cover
2、The decorative panel and the handle are connected to the control valve as shown below sequence.
10、Shower sets installation
Make connection of shower head, shower arm and wall water pipe. Use teflon to prevent leakage.
11、Handle shower installation
Install the handheld as picture shown.