Installation Guide

Unit: inch

Φ8.8"

1.8"~2.4"

16"

1/2-14NPT

2-1/2-14NPT

1/2-14NPT

36"~40"

47"~63"

78"~88"

7.1

2.68"

MAX40"

5.2"

103

1、The size of the embedded box that needs to be drilled

is 5.3"*6.7".

2、The depth of the embedded box is 1.8"-2.4". It's

better to drill the depth of 1.8"for blank wall.

wall

Tile surface

≤2.4"

"-2"

Hot water

Mixer

water

Mixer

water

cold water

5.Technical drawing of drilling size

4.Technical drawing of product

6、Pipe connection

Please drill the holes on the wall for the main body embedded part, hot and cold water inlet

pipes as well as shower arm connection pipes according to the basic product dimension drawing

as below.

Please make hot and cold water inlet pipe, the mixed water outlet pipe connect with control

valve,and tighten with the wrench

1、

2、

Testing Purpose: Flush the impurities and sludge in the pipeline

to avoid clogging and affect the effluent functions.

7、Water testing and sealing testing

1、After the pipe connection is completed, open the protective panel and cover, and then open the

cartridge, flush the pipeline; then close the cartridge to check the pressure resistance and sealing

performance of the pipeline, make sure there are no leakage.

2、Block each outlet pipe with a stopper then open the cartridge to check if the pipe joint is well-

sealed and the pipe condition under pressure to ensure no leakage.