I NSTALLATI ON MANUAL FOR SHOWER SYSTEM Website:https://dimakai.com Service Contact: service@dimakai.
1.Notifications Before Installation 3. Accessories List 1. When you open the product packaging, please check the product and accessories at first. If there is any discrepancy, please contact the company or our distributor immediately. 11 2. The hot and cold water supply pipe of the faucet must be properly connected. When facing the front of the shower set, the hot water supply is on the left and cold water supply is on the right. Incorrect connection will cause permanent damage to the cartridge.
4.Technical drawing of product 6、Pipe connection Unit: inch 1、Please drill the holes on the wall for the main body embedded part, hot and cold water inlet pipes as well as shower arm connection pipes according to the basic product dimension drawing as below. 16" 3° 1/2-14NPT 10 2、Please make hot and cold water inlet pipe, the mixed water outlet pipe connect with control valve,and tighten with the wrench 78"~88" Φ8.8" 1.8"~2.4" Φ7 1/2-14NPT 36"~40" 2-1/2-14NPT 47"~63" 2.68" MAX40" " 5.
8、The procedure of sealing the wall 10、Shower sets installation Use a parallel ruler to measure the flatness of the embedded box casing and the vertical wall surface. If the wall surface is not flat, it should be patched to ensure the embedded box casing and vertical wall angle meets at nearly ideal angle of 90, then lay the tile decoration. Make connection of shower head, shower arm and wall water pipe. Use teflon to prevent leakage. Tile surface wall outside the wall ≥0.
Care and Maintainance How to clean shower head nozzles 1. Just rub the nozzles with your finger or toothbrush to loosen any deposits, and then run hot water for a few minutes. 2. Put the showerhead into a pot. Consider using a smaller container that just about fits the shower head; this way, you will use less vinegar. You can also use a small bucket or plastic bin. Fill the pot with enough white vinegar to cover the showerhead.
