INSTALLATION INSTRUCTION Ni SHOWER ENCLOSURE TRUST MADE TMKRL08121 Please read this installation Instruction carefully before installing; Please sack the quantities of the accessories and make sure you have the fools beaded; it may also be necessary fo consult your filling supplier about the correct method for drilling your tiles; Shall any parts misunderstanding or other problems, please contact your local distributor or our company directly and you will get a satisfied newer.
MADE IN CHINA E[ElElaE]} 7 reified] po|10 Shower trey (for choice) 2 | H10 profile 3 | Well phy 4 1c388 prose 6 | Magnetic strips 7 | Movable glass 8 | Square top ber setter 9 | Militant 10] Roller 11| Cover 12| Cover 13] Special crew set 14] 1225 prose 15 Ford gloss
2 | Tools for installation i TRUST MADE ~ Impact drill Level Rubber hammer Pencil Glue S Lo Screw driver Tape Allan Wrench ke) 3 | Installation of Shower Tray place the waste hose into the waste pipe.
A trapezium wood hips fo fill the rubber gasket Into the split between the giant and the profile. Get the gasket wet before stuffing.
i TRUST MADE Use the glue to seal the slit between the wall and the profile,the fixed glass door and the tray to avoid the water leaks.
Maintenance of Shower Enclosure M 1.Cleaning TRUST MADE Please use a soft,dry cloth to clean the shower enclosure and shower tray. if there Is minor dirt , nce mocha! lot or sponge dampened in a mid detergent to clear remove substitution use alcohol. When cleaning with bath detergent,do follow its instructions and use comectly.
