Manual

Fig. 7 – Remove the cap from the top of the

powder die (#13865). The cap retains the

expander/powder funnel during shipping.

Fig. 8 – Make sure the expander/powder funnel

is free to move in the powder die and reinsert it as

shown.

Fig. 9 – With the cap removed and the

expander/powder funnel in position, you are now

ready to install the powder measure. Place the

powder measure on top of the powder die.

Fig. 10 – The powder measure is held in place by

the powder die clamp (#13986). Tighten in place, but

do not over tighten.

Fig. 7

Fig. 8

Fig. 9

Fig. 10