Instruction Manual

power cable and clamp and support
bin bracket (#10991) as shown in the
schematic on page 30. Fig. 6
The casefeed bowl assembly needs
to be placed on the casefeed post with
the Dillon logo and the on/off switch
f
acing you.
The casefeed tube (#20533*) should
now be inserted into the casefeed
adapter (#13654*)
Fig. 7 Note that
the tube is marked “up” on one end.
P
ress this end into the tube clip
(#13859) attached to the casefeeder
m
otor housing
F
ig. 8
.
This assembly is
now complete.
Step 3: Installing the Powder Measure
Remove the blue cap from the powder
d
ie (#20320) and loosely clamp the
powder measure in position. Fig. 9
Install the powder measure return rod
(#13960) through the 3/8” eyebolt
(#13089) mounted on the left rear of the
m
ain frame.
F
ig. 10
N
ow attach the rod
to the powder measure bellcrank using
t
he clip.
F
ig. 10
I
nstall the spring
(#14033) and wing nut (#13799) on the
rod and screw the wing nut up until you
feel light tension on the spring. Tighten
the powder measure clamp screws
(#14037).
Step 4: Installing the Spent Primer Cup
and Bullet Bin
Install the spent primer cup (#16699)
on the right side as shown on the
schematic on page 27. Fig. 11
Hook the bullet bin (#13756) and the
collection bin (#13484) on to their
respectiv
e brackets.
F
ig. 12
F
ig. 6 - Shown is the proper position of the
po
w
er cable (13539), clamp (13495), and
bin support bracket (10991).
Fig. 7 - The proper location and positioning
of the casefeed tube and adapter is as
shown above.
F
ig. 8 -
T
he end of the casefeed tube marked
“up” snaps into the clip at the base of the
casefeeder motor housing.
Fig. 9 - See arrow. A slight gap allows the
powder die to be adjusted without removing
the powder measure.
Fig. 10 - Note how the spring above the
wing nut is slightly compressed.
Clip
Spring
Fig. 11 - See the schematic on page 27 for
more details.
F
ig. 12 - Sho
wn is the proper location of
the cartridge collection bin. Note: the bul
-
let bin is replaced by the optional bullet
tray in this photo.
7
Super 1050, May 2007 5/21/07 12:00 PM Page 7