Instruction Manual

21
Lubrication
O
perating circumstances will dictate
the frequency of required lubrication. It
is highly recommended that the Super
1050 be cleaned and lubed after every
10,000 rounds of operation.
Use a high-grade, conventional wheel
b
earing grease –
d
o not use oil
.
Lubrication Points:
• Casefeed Plunger (#13073*), lube the
sides and bottom.
• Casefeed Plunger Roller (#13498) and
Bolt (#13333)
• Tappet (#12995)
• Rocker Arm (#13058), cam surfaces
and hole.
• Pivot Bolt (#13296)
• Primer Punc
h Base (#12849 - large or
#13307 - small)
• Lube the Indexing Lever Cam surface
(#10064) and Index Lever Shoulder
Bolt (#13276). With the handle in the
rest position, you will see the Index
Roller (#10996) come into contact
with the Lever Cam surface. The
Index Roller (#10996) also requires
periodic lubrication.
•
Alignment Pins (#12972 & #13515
located under the toolhead)
• Cam Guide Bolt (#12486) and its
mated slot
• Toolhead Bore (#20420 - lightly to
avoid rusting and/or freezing up)
• Mainshaft Lubrication – Use only 30
weight motor oil. DO NOT use a
penetrating lubricant such as WD-40,
Breakfree, etc…
• Swage Connecting Rod (#13417) and
Clevis Pin (#13522)
• Shellplate lock ring (#20311), bottom
surface to shellplate face.
• Shellplate center hole. It’s easiest to
lubricate the shellplate center hole
when changing from one caliber to
another.
W
e recommend that you use a droplet
of Blue Loctite on the threads of the fol
-
lowing bolts prior to reinstalling:
#13333, #13296, and #13276 (see pho
-
tos and sc
hematics).
casefeed plunger
(caliber specific)
13498
13333
12995
13296
13058
12849
large
or
13307
small
75% - 50% - 75% - 75%
12486
alignment pin
Super 1050 mainshaft
10999
toolhead bore
alignment
pin
casefeed cam
1
3417
13522
13276
11064
operating handle shown in
down position
20311
Super 1050, May 2007 5/21/07 12:00 PM Page 21