Instruction Manual

of the pocket, once properly swaged,
the dents will no longer be visible. Fig.
3
1
Primer System Change Over
Instructions
The Super 1050 has been shipped to
you with either the large or small primer
system installed. To change the system
f
rom large to small or vise versa, follow
these instructions:
Be sure all primers have been
removed from the primer system. Then
remove the Early Warning System and
the knurled cap. Then remove the primer
magazine (#22031 - large or #22030 -
small) and replace it with the new size
magazine. Be sure the key on the tip
(#14003 - large or #14024 - small) is in
the slot and the magazine is all the w
ay
down in place.
Fig. 32
Pull the operating handle to its down
position.
L
oosen the lever arm bracket screw
(#14037) and slide the bracket assem-
bly up four inches and lock it in
place. Fig. 33
Raise the operating handle, remove
the two primer feed body screws
(
#13363) and lift off the primer feed
body assembly (#20773).
Remove the toolhead ratchet (#11688)
by removing the bolt (#12486). Fig. 34
Remo
v
e the powder bar return rod
(#13960) from the powder measure bellcrank
lock link assembly (#11234) by releasing the
return rod clip
(#13929).
F
ig. 35
Remove the casefeed tube (#20533*)
and place it on y
our benc
h. Remo
ve
the toolhead.
F
ig. 36
F
or more infor
-
mation see the following section:
T
OOLHEAD REMOVAL.
Now remove the shellplate lock nut
(#13425) by loosening the four locator
tab screws (#13895) about four full
turns.
F
ig. 37
Loosen the ejector tab screw
(#13896) and swing the ejector tab
(#13189) out of the wa
y.
F
ig. 38
Next,
slide the casefeed plunger (#13073*)
back and remove the shellplate.
Rotate the primer slide stop (#13108)
90˚.
This will allow you to remove, and
replace, the primer slide (#20318 - large
or #20317 - small). Fig. 39
Next, remo
v
e the bushing (#13031 -
large or #13222 - small); spring
(#13858) and punch (#12849 - large or
#13307 - small) and replace them with
the parts for your new primer size.
Note that there is a specially designed
13
F
ig. 32 - Note the shape of the key at the
base of the primer magazine tip.
F
ig. 33 - Slide the br
ac
ket assembly up and
out of the way – retighten the lever arm
bracket screw to hold it in place.
Fig. 35 - After removing the clip and discon-
necting the rod, replace the clip in the rod
for safe-keeping.
Fig. 36 - To remove the toolhead unscrew
t
he toolhead bolt and remove.
F
ig. 34: Remove the toolhead ratchet by first
removing the bolt (#12486). See the
Toolhead schematic on page 27
Fig. 37 - The four lock ring screws need only
be loosened about four turns to remove the
shellplate lock nut.
F
ig. 38 - Loosen the screw and swing the
ejector tab out of the way.
Super 1050, May 2007 5/21/07 12:00 PM Page 13