Owner's manual

Be sure to secure the small, but important, screw

located at the rear of the bowl at the base. This little

screw (#13685) secures the entire bowl assembly to

the casefeed post (17123).

Fig. 8

7. The powder measure (#17817) is the next item

we’ll be installing on the machine. Familiarize

yourself with its operation – every complete stroke of

the powder bar dispenses one charge of powder. The

dispenser is hull activated.

Using a 7/16” wrenc

h, rotate the bolt located on

the end of the powder bar – counterclockwise will

reduce the po

wder c

harge weight, cloc

kwise will

increase the po

wder c

harge weight.

ig. 9

Be sure to install the powder measure plug

(#13921) here – see arrow

Fig. 9.

8. Remove the blue cap on the powder die

(#16744). Loosen the two Allen screws and place the

powder measure (#17817) on the powder die

(#16744). The clamp must lock into the groove of the

die, then secure the tw

o Allen screws firmly

ig. 10

9. Locate the parts bag for your machine. Enclosed

is a powder bar return rod (#17350)

Fig. 11. The

powder bar return rod (#17350) must be inserted into

the bellcrank from its left side. On the bottom of the

rod is a blue wing nut (#13799), spring and white rod

bushing (#18086). Slide this end into the receiver (

see

13685

Fig. 8

Fig. 9

Fig. 10

Fig. 11

#13921

SL 900, May 2007 5/21/07 11:51 AM Page 19