Users Manual

USER MANUAL
RGB Wireless Charger
Indicator light identification:
1.Connect a charger to the wireless charger.
The wireless charger supports fast wireless
charging.
To begin fast wireless charging, place a
mobile phone that supports fast wireless
charging on the wireless charger.
Suggested to use QC 2.0 or QC3.0 charger
(5V/2A and 9V/1.8A).
2.Place a mobile phone on the charger.
Check the charging icon displayed on the mobile phone’s
screen for the charging stauts.
Wireless Charger x 1
1 meter Type-C Cable (5V/2A) x 1
User manual x 1
Fully
Charging
ltem Name: Fast Wireless Charger
Interface: Type-C
Input Voltage: 5V/9V
Input Current: 2A/1.8A
Output Power: 10W(MAX)
Dimensions: 105X105X11.55mm
Package Contents:
0201
Charging Port
(Type-C Port)
Indicator light
RGB light
Silicone
0403
PC+ABC
（Flame retardant material V0）
RGB light button
9 kinds of RGB changes
Working status Color of light
Connected to a power outlet,
the white light will flash 3 seconds,
then off and standby.
Full charged
Charging
1.Not charging properly due to
a general error
2.Low power input
White+Off
White
Off
Flashing White
Charging coil
G6
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC ID： 2AVI4-DT-G6
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. During the operation of device a
distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.