Instruction Manual

20 mm
31.2 mm
2.7mm
7143-27GY/W57-CK
Instruction Manual
1 x Cork Wireless Charging Pad
1 x Limestone Stand
1 x Instruction Manual
Input: 5V/2A
Wireless Output: 5W
Using the Charging Stand:
The cork wireless charging pad can be
placed in the limestone stand for a upright
charging surface.
To use the charging stand in the upright
position, simply thread the top of the
charging pad through the bottom of the
limestone stand.
Place the USB cable along the cut out
channel to the back of the stand, then
place on the table.
Wireless Charging Mobile phones and
other electronic devices:
Connect the USB cable of the charging
pad to a power source. LED indicator
(2) will glow RED when the device is in
wireless charging standby.
Place the wireless charging supported
mobile device vertically on the wireless
charging surface(1), LED will glow BLUE
when device is charging.
Phone will begin to charge automatically,
wireless charging LED(3) will turn off when
the device is fully charged.
Once fully charged remove the device.
Note: When wireless charging, if the LED
a wireless charging device or there is an
object between the device and charging
surface interfering with the charging.
process.
1.
•
•
•
2.
•
•
•
•
**
1.
2.
3.
4.
•
•
Wireless Charging Surface
LED Indicator
Limestone Stand
USB cable
What’s included:
Functions:
Instructions:
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F(0°C) or above
115°F(45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above the
Do not use the device if damaged or
Do not disassemble the device. For
professional. incorrect reassembly may
or temperatures above 104°F may cause
explosion.
use only identical replacement parts to
ensure product safety.
Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove any attachments from the
phone before charging on this device,
attachments can interfer with wireless
charging and lead to over heating.
•
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
SAFETY PRECAUTIONS:
13. This product is made from cement.
If drop, it may crack. Please handle with
care.