User manual

Chapter 3: Configuration
Testing Your Configuration
1. Load DAHDI drivers into the kernel using the modprobe utility. The
appropriate driver for the TE120 Series cards is
wcte12xp. Users in all
countries except Australia should use the following modprobe
command:
# modprobe wcte12xp
# dahdi_cfg -vv
2.
Run dahdi_tool from the command line and see if the span turns
green for each span you have connected.
# dahdi_tool
3.
Execute the following Asterisk command to see if the span came up
successfully.
# asterisk
# asterisk -vvvr
Digium, Inc. Page 49