User manual

Release 1.01 Digium, Inc. Page 29
Chapter 2: Card Installation
2. If your card has any green FXS modules, add the following:
fxoks
This uses kewl start signalling which is loop start with disconnect
supervision. For example, a TDM880P card would be configured as
the following:
fxoks=1,2,3,4,5,6,7,8
An example TDM844P card configuration would be:
fxoks=1,2,3,4
fxsks=5,6,7,8
3. Set your loadzone and default zone for your country. If you are not in
the United States, you will want to change the default configuration
from US to your own two letter country abbreviation. Save the file
and return to the command line.
#modprobe wctdm24xxp
#ztcfg -vv
Note: The TDM800P card uses the same driver for this setting as the
TDM2400.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]