User manual

Page 28 Digium, Inc. Release 1.01
Chapter 2: Card Installation
Zaptel Configuration
The following steps are necessary for Zaptel configuration:
1. If your card has any red FXO modules, add the following:
fxsks
This uses kewl start signalling which is loop start with disconnect
supervision. For example, a TDM808P card would be configured as
the following:
fxsks=1,2,3,4,5,6,7,8
Note: You should have identified the type of TDM800P card when
you received it. If you are not sure, refer to Module Identification on
page 18 for assistance.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]