User manual

Page 22 Digium, Inc. Release 1.01
Chapter 2: Card Installation
FXS and FXO Connection
The TDM800P card provides eight RJ11 connectors for access to the FXS
and/or FXO modules installed in the available slots. The diagram in
Table A-1 on page 43 provides the pinout for this connector.
Hardware Installation
1. Now that you are acquainted with your card, power down your com-
puter and unplug it from its power source.
2. Attach a static strap to your wrist and open the case.
3. Remove the bracket place holder and insert the card into a 3.3 or 5
volt PCI slot (PCI 2.2 or greater). See Figure 4.
Figure 4: Insert the Card
Caution.
Only qualified service personnel should continue with
hardware installation and configuration of the TDM800P card.
Users should not attempt to perform these functions themselves.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]