User manual

Release 1.01 Digium, Inc. Page 17
Chapter 2
Card Installation
This chapter provides the following information:
 Unpacking the Card on page 17
 Shipment Inspection on page 18
 Module Identification on page 18
 FXS and FXO Connection on page 22
 Hardware Installation on page 22
 Software Installation on page 25
Unpacking the Card
When you unpack your card, carefully inspect it for any damage that may
have occurred in shipment. If damage is suspected, file a claim with the
carrier and contact your reseller from which the card was purchased, or
Digium Technical Support at 1.877.LINUX.ME (1.877.546.8963). Keep
the original shipping container to use for future shipment or proof of
damage during shipment.
Note: Only qualified service personnel should install the card. Users should not
attempt to perform this function themselves. The installer must ensure that the
equipment is permanently connected equipment, pluggable type B or connected
to a socket-outlet that has been checked to ensure that it is reliably earthed in
accordance with the National Electrical Code.
This card is intended for installation in a Restricted Access
Location (RAL) only.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]