Specifications

Digium, Inc.
If the X Window System is running, stop the application
cause a conflict with Asterisk.
2. Check to see if your PATA IDE hard drives are running with
levels set. Advance user can perform an
hdparm on your
interface.
Check the current mode using this command:
hdparm -vi /dev/[IDE Device]
Use this command to set the drives into UDMA2 mode
hdparm -d 1 -X udma2 -c 3 /dev/[IDE Device
If you are still having problems, contact your reseller from
was purchased, or Digium Technical Support at 1.877.DIGI
(1.877.344.4861).
Use hdparm with caution as the man page states tha
corruption can occur when using incorrect settings
review the man page for hdparm and make sure yo
the risks before using this tool.
http://arttel.ru
http://arttel.ru/shop/platy-dlya-ip-ats/voip-plata-digium-wildcard-tdm800p