User manual

Chapter 3: Configuration

3. Specify the channel definitions. The format is:

A list of valid devices are specified in the sample system.conf file.

If your card has any red FXO modules, add the following to

system.conf:

fxsks =

fxsks uses kewlstart signalling, which is loopstart signalling with disconnect

supervision. For example, a TDM808E card would be configured as the

following:

fxsks = 1-8

fxsks = 1,2,3,4,5,6,7,8

You should have identified the type of 800 Series card when you received it.

If you are not sure, refer to

Module Identification on page 22 for

assistance.

Note: The 800 Series cards do not support Ground Start signaling.

Digium, Inc. Page 39