User manual

Chapter 2: Card Installation
be purchased. The shorting strap on the PWR2400B should be removed if
a second power supply is used.
The PWR2400B does not connect to any bus inside the computer. It may
be used wherever there is an available PCI-size bracket such as a PCI,
PCI Express, or AGP slot.
Note: The PWR2400B is not intended to supply power to any other
device, it is intended only to be used with UL Listed Digium analog
cards.
5. Replace the cover to your computer.
Electrical Shock.
To reduce the risk of injury, damage to the unit or your
equipment, do not attempt to apply power to the unit while the
case is open.Personal injury or damage to the unit could occur
if the modules are touched while powered is applied.
6. Plug all outside phone lines to the FXO ports (corresponding to the
red modules) and connect all phones to the FXS ports (green
modules) as needed using a patch panel or punch block. See Table A-
1 on page 56 for the pin assignments.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord, e.g.: for
Australia use only line cords complying with AS/CA S008:2010.
Digium, Inc. Page 29