User manual

Chapter 2: Card Installation
FXS and FXO Connection
The 800 Series cards provide eight RJ11 connectors for access to the FXS
and/or FXO modules installed in the available slots. The diagram in
Table A-1 on page 56 provides the pinout for this connector.
Caution.
Only qualified service personnel should continue with
hardware installation and configuration of the 800 Series card.
Users should not attempt to perform these functions themselves.
Slot Compatibility
Check the type of card you received to be sure it is compatible with your
PCI slot. To determine which slot you have, identify it by comparing it to
those shown in Figure 4 on page 26.
Slot Number:
0: AGP Pro Slot
1: 64-bit 5.0 volt PCI Slot
2: 64-bit 3.3 volt PCI Slot
3: 32-bit 5.0 volt PCI Slot
4: PCI Express Slot
Digium, Inc. Page 25