USB 3.0 External HDD Enclosure 3.
Foreword Congratulations on your purchase of our product! We will show you a new storage concept with safety and convenience, It is our pleasure to give you the best solution to expand your HDD`s Capacity and enhance your data`s reliability in PC system or Mac system. Before using the product, please read this manual carefully for further recognizing of the product. I. System Requirement Hardware requirement: a PC or Notebook with free USB interface Operation system: Windows 7/Vista/XP/2000 II.
IV. Hardware Install 1. Slide the button to [OPEN] position, 2. Slide the top cover to the direction of USB socket 3. Remove the top cover 4. Connect the 3.5" (8,89cm) SATA HDD to the 22pin SATA connector at the rear of the HDD firmly 5. Push the HDD into the enclosure slowly and carefully 6. Slide the top cover to the main case 7. Slide the button to the [CLOSE] position 8. Insert the enclosure to the attached stand 9. Connect the USB 2.0 connection cable to enclosure and PC 10.
V. Driver Installation a. Under Windows 2000/XP/Vista/7: No driver needed Under system Windows 7/XP/Vista/2000, system will automatically detect the new hardware and finish the setup! An icon will appear on the right-bottom area of the system toolbar as below: Congratulations to enjoy this product now! VI. Power Supply: Power Supply: Voltage input: AC 100~240V, 50/60Hz Voltage output: DC 12V/2A VII. Backup software installation and usage A. Software installation and use 1.
2. Click [Agree] to accept the license agreement 3.
4. Click [OK] to finish installation B. Use back-up function 1.
2. Press the backup button, then program will appear [Please select file(s)], click [OK] 3.
4. Follow the instruction to press the button again or click [Start] 5.
6. Backup file finished now you may check the file on right window VIII. Remove the external enclosure Before removing this unit from your computer, please finish the following procedures for a safe removal: 1). Click the icon in the [Desktop] window of your computer 2). A [Safely Remove Hardware] message window will appear, click the [Stop] button 3). [It is now safe to remove the USB device] message will appear, close the [Safely Remove Hardware] window 4).
