Datasheet

- 16 -
• Auto Scan Mode:
You can start the OSD first and press “F4” to enter the Auto Scan Mode. If you want
to scan the PC, you must use the Smart View Setting to select the Auto Scan Time in
the System Setting for the residing time, which includes 5 sec, 10 sec, 20 sec, 30
sec and 60 sec. You can adjust the Channel Display Mode and Channel Display
Time from the Channel Display mode. By then, all keys on the panel, keyboard and
mouse are not operable. You can only use the ESC key to exit the Auto Scan Mode.
• Security Mode:
Switch the Security Level from “None” to “Low” in the System Setting, and enter your
Password (“A~Z”,“0~9”, a maximum of 12 characters), and the security will be
effective after you confirm the Password. The use of the Console Lock Time is to set
the time to enter a security mode after the keyboard and mouse has idled for a
predetermined time. Once you enter into the security mode, you need to enter the
correct password before you can move the mouse or enter any key from the
keyboard. You need a correct password to operate the whole system normally.
• EDID & DDC: A vast majority of computer monitors supports the Extended Display
Identification Data (EDID) and allows data access by Display Data Channel (DDC).
The KVM also supports these two specifications, but the KVM only reads the EDID
of the Monitor when the KVM is on. If it is necessary to change monitors during an
operation, please use the Console Reconfirmed function to read the EDID again.
• F/W Update: This product provides a firmware update function. You can contact
your distributor for downloading application programs and updated files. Use the
F/W Update Cable for the update. Please turn off all PCs before carrying out the
update, and do not disconnect the power during the update process.
Procedure:
1. Download and install the application program KVMISP.msi.
( Note: This program has to be run only in Win98SE, ME, XP or 2000 ).
2. Connect the F/W Update Cable, and the PC end is RS-232 port (COM-X)
while the KVM end is the updata port.
3. Power on the KVM and run KVM-ISP.exe. Select the COM port.
4. Select the Download function and specify to update the KVM-XXXX.KVM file.
5. After the update completes (which takes about 1.5 min), power off the KVM.
Unplug the F/W Update Cable. Power on the KVM again.
6. You can use the system setting “F1”- Information in the OSD to examine
whether or not the F/W version is the updated version.
Important Note: What should I do if I forgot my Password?
After you enter a wrong password for 5 consecutive times, a time delay bar will appear, and a
set of “Magic Numbers” will show up at the bottom. Record the magic numbers and contact
with your distributor.