Datasheet

- 11 -
OPERATION
Port Selection
The LCD KVM provides fours switching methods: Manual Key, Hot Key,
Mouse Clicking and OSD.
• Manual Key
It is the simplest switching method. You just need to press the Port Selection Switch
on the front panel of the KVM. The Selection LED (Red) is on, indicating that you are
switching to the corresponding port.
Note: 1. The Port Selection Switch functions only when connected to a PC.
2. If the Offline Skip of the OSD System Setting is Auto, then you cannot make any
switch when pressing an offline Port Selection Switch.
3. For Auto Scan Mode, none of the Port Selection Switches functions.
• Hot Key and Mouse Clicking
Hot key and mouse clicking are applicable for switching a small section. You can select
the SVS (Smart View Setting) from the OSD of the PC first (for a quick switch of PC)
and use the keyboard (press the Ctrl key twice) or the mouse (press and hold the
middle button while pressing the left or right button) to switch to the previous or next
set of PC.
Note: The mouse must have at least 3 keys. As far as you select a PC with the SVS,
you can use this method for the switch.
• OSD (On Screen Display)
Press the NumLock on the keyboard twice or simultaneously press the Push Buttons 1
and 2 of the Port Selection Switch on the KVM panel to start the OSD. Use the Up,
Down and Enter keys on the keyboard to switch or directly move the mouse to the
target PC, and then double click the left button.
Additionally, you also can use the numeric keys to enter the direct switch. For example,
if you want to switch a PC to the Slave KVM port 04 under the Master KVM port 03,
then you can start the OSD and then directly enter 0304. If you are using a standalone
machine, then just enter the first two digits.
More OSD related information are given in the following OSD sections.
On Screen Display (OSD)
• Start
Press the NumLock twice or the Port Selection Switches 1 and 2 on the panel to
enter the OSD.
Note: If you have modified the Hot Key for starting the OSD and are unable to enter the OSD
by pressing NumLock, then you can start the OSD by using the Port Selection Switch
first, and then press F9 to enter into the System Setting to modify the options of the
OSD Entry Hot Key.