Instructions

The numbers help you to find the right way to insert the
cap onto the IDC. Press the cap down onto the IDC and
make sure that the wires are deeper than the tiny teeth
inside of the IDC slots.
Connect the drain wire to the shielded shell housing and
tie up the cable tie and finish.
Keystone Module CAT 6
A
Assembly Instruction for
DN-93617 & DN-93617-24
Strip approximately 40 mm of the cable jacket
(the foil shielding should be cut to approx.
15 mm) and separate the wire into 4 pairs.
Wiring Configurations
T568 A T568 B
Pin 5 White/Blue Pin 5 White/Blue
Pin 4 Blue Pin 4 Blue
Pin 1 White/Green Pin 1 White/Orange
Pin 2 Green Pin 2 Orange
Pin 3 White/Orange Pin 3 White/Green
Pin 6 Orange Pin 6 Green
Pin 7 White/Brown Pin7 White/Brown
Pin 8 Brown Pin 8 Brown
Insert the wires through the cap and lay them into the
correct slots, according to the wiring diagram on the
cap. Trim the wires flush with the cap. It is strongly
recommended that the tip of the wire protrudes only
0.15 - 0.20 mm.
Close the outer cap by pushing down
both sides until it clicks.