Instructions

max.
0,15-0,20 mm
Step 3:
TRIM WIRES
Trim the wires ush with the wire manager. It is
strongly recommended that the tip of the wires
protrude max. 0.15-0.20 mm.
Step 4:
WIRE INJECTION
The numbers help you to nd the right way to
insert the wire manager onto the IDC. Press the
wire manager down onto the IDC.
Schritt 3:
ADERN SCHNEIDEN
Schneiden Sie die Adern bündig an dem Ader-
manager ab. Es wird dringend empfohlen, dass
die Spitze der Adern max. 0,15-0,20 mm her-
ausragt.
Schritt 4:
ADERN VERPRESSEN
Anhand der Zahlencodierung erkennen Sie die
korrekte Richtung in die Sie die vorkonfektionier-
ten Adermanager auf die Schneidklemme aufset-
zen können. Drücken Sie den Adermanager auf
die Schneidklemme.