Instructions

40 mm
40 mm
40 mm
40 mm
PIN 5 4 3 6
T 568A
PIN 1 2 7 8
PIN 5 4 3 6
T 568B
PIN 1 2 7 8
1. Paar/Pair
2. Paar/Pair
3. Paar/Pair
4. Paar/Pair
1. Paar/Pair
2. Paar/Pair
3. Paar/Pair
4. Paar/Pair
(S/FTP)
(U/UTP)
Step 1:
S/FTP: REMOVE THE CABLE JACKET
Strip approximately 40 mm of the cable jacket
and separate the wires into 4 pairs.
U/UTP: REMOVE THE CABLE JACKET
Strip approximately 40 mm of the cable jacket,
cut off the plastic cross and separate the wires
into 4 pairs.
Step 2:
WIRING CONFIGURATION
Insert the wires through the wire manager and
lay them into the correct slots, according to the
wiring diagram on the wire manager.
Schritt 1:
S/FTP: KABELMANTEL ENTFERNEN
Entfernen Sie etwa 40 mm des Kabelmantels
und teilen Sie die Adern in 4 Paare auf.
U/UTP: KABELMANTEL ENTFERNEN
Entfernen Sie etwa 40 mm des Kabelmantels,
schneiden Sie das Kunststoffkreuz ab und teilen
Sie die Adern in 4 Paare auf.
Schritt 2:
VERDRAHTUNGSVERFAHREN
Führen Sie die Adern durch den Adermanager und
legen Sie diese entsprechend des Belegungs-
plans in die richtigen Führungen ein.