Datasheet

108M Wireless USB Adapter User Guide
Chapter 2: Installation Guide
2.1 Hardware Installation
1. Connect one end of the USB cable to the Adapter.
2. Connect the other end of the USB cable to the USB port on your computer. Because
the Adapter gets its power from the host, there is no external power supply. The LED
should light up when the Adapter is plugged in and the PC is on.
2.2 Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the installation procedure for
Windows 2000, XP. The Setup Wizard will install the Wireless Drivers & Utility and
drivers.
When you install the hardware before the software, the system will prompt “Found New
Hardware Wizard”, click Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 2000 and Windows XP are very similar. The following
setup steps are for Windows 2000.
2.2.2 Software Installation for Windows 2000
1. I Insert the Resource CD into your CD-ROM drive, click Start and choose Run. In
the field that appears, enter F:\UWCU\Win2000_XP\Setup.exe (if “F” is the letter of
your CD-ROM drive), figure 2-1 should then appear.
2. You can click Cancel to end the installation on the Preparing Setup screen, figure
2-1. Otherwise, the Setup Wizard will display a screen similar to that shown in figure
2-2 after a moment.
Figure 2-1 Wireless Client Utility – Install Shield Wizard
3. To continue, click Next on the screen, figure 2-2. Click Cancel to end the
- 3 -