Datasheet

9
Diagnostics
If you experience any problems with the 32-bit CardBus
10/100Mbps NWay Fast Ethernet PC Card, first verify that the
appropriate driver is loaded, that the proper grade of cable is
employed for the network connection, and that the supporting
hub/switch is functioning properly.
1. As certain that the 32-bit CardBus 10/100Mbps NWay
Fast Ethernet PC Card is fully and firmly seated in the
32-bit CardBus PC Card slot.
2. Check the length and rating of connecting cables.
3. Replace the adapter in question with a verified adapter and
run ENCBRSET.BAT diagnostic tests on the driver
diskette at directory of \Rset\.
4. Install the questioned adapter in another notebook PC and
run the tests again.
Remove all other PC Card from the notebook PC and run the
tests again. If the diagnostic run is abnormal, then there is
probably an interrupt number conflict that will have to be
resolved manually by a CMOS Setup utility run after you have
reinstalled all of the expansion cards.
The Diagnostic Program provides two levels of testing:
Adapter Basic Diagnostics and Network Diagnostics.
Adapter Basic Diagnostic does not require substitution of a
loopback cable. All procedures of the Adapter test may be
carried out with the network cable connection in place.