User manual

12
4. SYSTEM CONFIGURATION
Before using the network camera, make sure you have installed the supplied software, “Video
Viewer”, and configure network settings. If not, please refer to your installer or the installation guide.
Note: It’s recommended to consult with your installer before changing system
configurations.
Note: You need to be the supervisor to enter the system configuration page. If not,
please re-log into the camera with the supervisor user level.
Click “ ” and select “ ” to enter the system configuration page. All the system configurations
are listed as a tree structure on the left panel as follows.
Main Menu Sub-menu What you can do for this function?
General 1. Check the firmware version & MAC address of the camera.
2. Change the camera title.
Log Check the system event logs.
Account 1. Create a new user account with different access privilege.
2. Modify or delete an existing user account.
OnLineUser Check the current online user(s).
Trigger 1. Enable / disable the motion detection.
2. Set the motion detection area.
3. Select the event notification method.
Network Configure network settings.
QoS Limit the data flow for live streaming.
DDNS Enter DDNS information when the network type is PPPOE or DHCP.
SNTP Synchronize your camera time with the networked computer systems.
FTP Enter the FTP information for event notifications when “FTP” is chosen in “General” →
“Trigger”.
MAIL Enter Email information for event notifications when “Email” is chosen in “General” →
“Trigger”.
Filter Choose to permit or block the IP address(es) which can access this camera.
UPnP Allow this camera to be detected among devices within the same network area for easy and
quick usage.
Video Set the image resolution, quality and frame rate.
Color Adjust the color performance.
Time Set daylight saving time and the current time.