User`s manual

following methods, depending on your network operating environment:
 Automatic IP Address Assignment
 Manual IP Address Assignment
3.2.5 Host Names and Host Name Rules
The Host Name of the Server is specified by “DN-13007”in Factory Parameter. If you
put two or more MFP servers in your local area network, to avoid using same Host
Names you have to change the Host Names by using MFP Server Control Center or
server’s web pages. If your Host Name is longer than 15 characters, Digitus DN-13007
USB MFP server limits the length of Host Name to 15 characters.
3.2.6 Set the IP Address Using DHCP
Follow the instructions below to get an IP address using DHCP:
1. Edit or create a scope in the DHCP manager of the DHCP daemon. The entries
included in this scope should contain the following parameters:
y range of IP addresses
y subnet mask
y default router IP address
y DNS server IP address
y lease duration
2. Activate the scope. The MFP server automatically gets the DHCP parameters. If
you are using DNS, you may include at least one DNS server IP address in the
DHCP scope or manually set DNS server IP in MFP server’s web pages or MFP
Server Control Center tool.
3.2.7 Set the IP Address Using Control Center
1. Install MFP Server Control Center. MFP Server Control Center is available in the
Digitus DN-13007 USB MFP Server Product CD.
2. Start MFP Server Control Center and Auto-searching MFP server window will
appear.
3. If the tool finds MFP servers in your local area network, then you have to select
a MFP server from the server list.
9