User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
9. Click Browse button to choose the file of new Digitus DN-13007 firmware.
10. Click Upload button to start firmware upgrade.
11. Wait about 15 seconds for system reboot.
Procedure C: Using Init Button and TFTP Client to Upgrade
Firmware in Emergency
1. Simultaneously press Init button and power on (plug the power adaptor line)
the server until LED indicators of Power, USB1 and USB2 blink. Please note
that after that, the servers will operate using the factory default values
after restarting, i.e., your MFP server’s configuration will recover to
Factory Default values.
2. Start the TFTP client Tool: Image Burner
3. Type the server’s Fallback IP address: 192.168.1.100 and click Open Image to
open your new firmware. Please note that you must configure your PC’s TCP/IP
such that PC and server belong to the same LAN, i.e. PC’s IP is 192.168.1.xxx
and subnet mask is 255.255.255.0.
77