User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
Procedure B: Using Server’s Web Pages
1. Power on Digitus DN-13007. Suppose Digitus DN-13007 is in DHCP mode.
2. Check Digitus DN-13007's IP address
.
3. First, run Digitus DN-13007 control center. The control center will
automatically search Digitus DN-13007 on the LAN. Then Digitus DN-13007's
IP address will be shown in control center.
4. Run any web browser, like Microsoft Internet Explorer. Go to http://a.b.c.d to
access Digitus DN-13007's home page, where a.b.c.d is Digitus DN-13007's IP
address.
5. Click CONFIG.
6. Login Digitus DN-13007 with administrator "admin" and password "admin".
7. Click Maintenance.
8. Click Upgrade Firmware.
76