User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
Enable Raw TCP Printing/JetDirect
- TCP Port (USB1): 9100
- TCP Port (USB2): 9101
SMB/CIFS Print/File Server: enabled
- Internet Access: disabled
- Server Authentication: disabled
FTP Server: Enabled
- FTP Port: 21
- Passive Mode: enabled
- Set Maximum Session Number: 5 (enabled)
- Server Authentication: enabled
- Allow Anonymous Login: disabled
SANE Server: enabled
- SANE Port: 6566
Enable UPnP: enabled
SNMP
Authentic Community: public
Trap Community: public
Trap Address: 0.0.0.0
SysContact: My_Email_Address
SysName: Digitus DN-13007 USB MFP Server
SysLocation: www.digitus.info
EnableAuthenTrap: 2 (disabled)
SNMPv3: disabled
User Account
Administrator:admin
Password: admin
74