User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
Chapter8 Control Center
This chapter describes how to use MFP Server Control Center in your Windows.
8.1 Installing Control Center
1. Click Install Product button.
2. Click Next, if you see Next button in installation windows.
3. Click Finish.
8.2 Using Control Center
8.2.1 Use Tools of Control Center
You can use the following tools to help you using the MFP server:
Auto Search : renew to auto search the existing MFP servers in network
IP Search : search the MFP server by IP address
Refresh : refresh the highlight list’s server status
Go to web : go to web pages of the highlight list’s server
55