User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
2.3 Physical Description
2.3.1 Ethernet Connector
The network connector of this Server is designed for 10 Mbps or 100 Mbps Ethernet
networks and connects to the network via a twisted pair category 5 cable (10baseT
and 100baseTX) or better.
2.3.2 USB Host Ports
This Server has two USB host ports which are USB 1.1/2.0 low, full, and high speed
compliant and successfully tested with USB 1.1/2.0 printers, Mass Storage, and
AIP/MFPs.
2.3.3 Init Button
The Init button is used for:
performing a Factory Default of the Server, which will restore most of the
parameters and settings to factory default values
performing the new firmware upgrade using in fallback
2.3.4 Indicators
Power Indicator is lit while power is applied. If it is not lit, or if it blinks, there
is a problem with MFP server or Power Adapter.
Link Status is lit while network is applied. If it is not lit, it indicates that the
server does not connect to network.
Status Indicator blinks to indicate network activity.
USB1 Indicator is lit while an USB device connects to USB1 Port of MFP server.
If it is not lit, or if it blinks, there is a problem with the USB device or the MFP
server.
USB2 Indicator is lit while an USB device connects to USB2 Port of the MFP
server. If it is not lit, or if it blinks, there is a problem with the USB device or
the MFP server.
5