User`s manual

1. Type Dos command as “ftp”
2. Type “open server’s Host Name” or “open server’s IP address”. If you have
changed the default FTP port : 21 to the new value, you have to add the new
port number in the tail of command as “open server’s Host Name ftp port” or
“open server’s IP address ftp port” .
3. If you set Enable Server Authentication in FTP server protocol settings
you have to type user name and password to login to the server; if you set
Allow Anonymous Login, you can use the user name “anonymous” to login
with Read-only permission. If you clear server authentication, you do not need
username or password to login server. You can add user name and password in
User Account box by MFP control center or server’s Web page.
4. Perform FTP commands to use this FTP server.
6.6 Formatting Disk
1. Go to the Server’s web page and click CONFIG
2. Login your administrator (default: admin) and password (default: admin).
3. Click Maintenance.
4. Click Format Disk.
5. Now you can format the inserted USB disk or USB flash disk to FAT16 or FAT32
48