User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
number.
Enable Passive Mode: select the item, if you want to allow that your
FTP server can accept passive mode command.
Enable Server Authentication: select the item, if you want to share
your storage with user level security which requires user name and
password to login. If you clear the item, your storage will be shared
without security.
Allow Anonymous Login: select the item, if you want to allow the
user “anonymous” to login your FTP server with read-only permission
and server will not check the password. If you clear the item, your FTP
server will not support anonymous login function.
6.5.2 Setting up File Server Using Web Pages
1. Go to the web page, click CONFIG
2. Login your administrator (default: admin) and password (default: admin).
3. After you login successfully, click Supported Protocols.
4. Set up File Server Configuration:
A. Set SMB/CIFS Print/File Server
45