User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
4. Select the desired printer driver and click Set Port to Printer.
5. If you can not find any printer driver in Printer List, please install your printer
driver first or click Add New Printer to install the printer driver.
4.4.3 Using Standard Windows Method for Raw TCP Printing
Windows Platform: Windows 2000, XP and 2003
1. Open Printers and Faxes
2. Right-click the printer for which you want to change settings, and then click
Properties
3. Clear Enable bidirectional support and click Add port, and then click
Standard TCP/IP Port from the dropdown and click New port.
4. The "Add Standard TCP/IP Printer Port Wizard" will pop up and click Next.
5. In the Printer Name or IP Address box, type Host Name of the MFP server
(default: DN-13007) or IP address of MFP server. In the Port Name box, type
USB1_RAW or USB2_RAW for printer connected to USB1 port and USB2 port,
respectively.
# If your server is running on a different LAN than your Windows PC such
Internet PC, you must type server’s IP address in Printer Name or IP
Address box.
6. Click Next.
7. Click Custom/settings.
8. The click Settings and confirm that the settings are as below. The default Port
Number values are 9100, 9101 for USB port 1 and USB port 2, respectively.
Refer to server’s web pages or MFP Server Control Center tool, you can get
exact values. Click OK.
23