User`s manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Product Overview
- Chapter3 Basic Installation
- Chapter4 Adding Printers in Windows
- 4.1 Overview of Installation Methods
- 4.2 Connecting the Server
- 4.3 Setting up Local Windows Printer Driver
- 4.4 Adding Network Printers in Windows
- 4.4.1 Using Standard Windows Methods for LPR Printing Protocol
- 4.4.2 Using Control Center for LPR Printing
- 4.4.3 Using Standard Windows Method for Raw TCP Printing
- 4.4.4 Using Control Center for Raw TCP/JetDirect Printing
- 4.4.5 Using Standard Windows Methods for SMB/CIFS Printing
- 4.4.6 Using Control Center for SMB/CIFS Printing
- 4.4.7 Using Standard Windows Method for IPP Printing
- Chapter5 Adding Printers in Unix/Linux
- Chapter6 File Server Function
- Chapter7 Scan Server Function
- Chapter8 Control Center
- Chapter9 Server’s Web Pages
- Chapter10 Email Alerting
- Chapter11 SNMP
- Chapter12 Troubleshooting
- Chapter13 Restore Factory Defaults
- Chapter14 Upgrade New Firmware
- Chapter15 Init Button
4. Set your printer names in Printer Name box and then click Apply.
3.3.2 Storage Names
The local drives of the two storages in USB1 port and USB2 port are named as
USBx_DxPx, where USBx represents the USBx port, Dx represents the the x-th Disk
(in particular to card reader plugging in multiple cards) and Px represents the x-th
partition.
3.3.3 Scanner Names
The name of connected scanner of HP office jet series consists of the “vender” +
“model”. For example, the scanner name of HP PSC 1300 series office jet is named as
“HP PSC 1300 series”.
15