User manual

14
F. After you finish using the USB device, click the USB device in the Control Center
and then click the “Disconnect” button to disconnect the USB device. Other PCs
can not “Connect” the USB device until you “Disconnect” that USB device. That is
to say, only one PC is allowed to connect the USB device at the same time.
4.6 Auto-Connect Printer
The method described in section 4.5 is so-called manual-connect, which means
users must manually connect the USB device before using that device, and must
manually disconnect the USB device after using the device, otherwise nobody else
can connect this device. However, for printers and scanners (and MFPs), the USB
device server supports auto-connect so users don’t need to manually
connect/disconnect. This and the next sections show you how to do this.
After the driver is installed as described in section 4.4, you can see a newly created
printer in the Control Panel’s “Printers and Faxes”. Follow the steps below to do a
NetUSB auto-connect printing.
A. In the Control Center, click the USB device server that has the desired printer
(or MFP) attached.
B. Click the desired printer (or MFP).
C. Click the “Auto Connect Printer” button and choose “Set Auto-Connect Printer”.
The following figure will appear.