Electric Height-Adjustable Desk Quick Installation Guide DA-90407 1
Introduction Do a good deed for yourself and your health with this height-adjustable table frame from DIGITUS®! The height of the table can be adjusted conveniently using the integrated control panel from 73 to 123 cm. Installation is relatively easy to carry out thanks to pre-assembled table elements. The table allows for a maximum load capacity of 50 kg, which is designed for monitors, notebooks and common work materials. The C-shaped pedestal design affords you the maximum amount of legroom.
Attention: The drawings below are only for reference which might be slightly different from the actual object, please in kind prevail. Any tools missing or installation problems, please contact the customer service firstly.
Mounting instructions Step 1) Install the lifting column Rotate the column after inserting it to the bottom to avoid height difference. Long side of the column Short side of the desktop Install the lifting column ② to the tabletop ①, then tighten the screws B with allen key D. Insert ① Insert the hexagon head of the column along the wiring trough, the side of the wire head facing the motor. ② Rotate the column after inserting it, making the screws on the supporting beam into the column slot.
③ + ④ Tighten the screws (B) with 4*4 allen key Step 2) Install the feet Connect lifting columns ② to the feet ④, tighten the screws C with allen key D.
Step 3) Install the hand switch Fix the hand switch with the screws A and tighten it with 5*5 wrench D. Step 4) Connect all cables to the adapter Connect the power after the wiring is complete. Connect the switch cable to the DC port and the motor cable to the M1 port. Insert the adapter ⑥ to the bracket of the tabletop.
Fix the cables to the tabletop with cable management ⑦ to keep the desk tidy.
Operation instructions Hand switch Product specification • DC input:19-33VDC, 150W • Output M1:19-33VDC, 4A • Number of controlled motors:1 PC • Standby power:<0.5W • Overload protection • Overtime protection • Sensor anti-collision protection (first gear) • Working frequency: Work 2 minutes, rest 18 minutes • Hand-switch and controller are combined into one, easy to operate and install • Two buttons, including “▲”,“▼” 1. "▲" Up button, control the standing desk to move upwards 2.
Reset 1. 2. At the lowest position, long press the down button for more than 5 seconds to enter the reset state, until the lifting system bottoms out and the rebound stops, the reset is successful. When the lifting system fails, release the button and long press the down button until the lifting system bottoms out and rebounds and stops, and the reset is successful. Anti-collision function 1. Built-in sensor, when encountering any objects, the device instantly stops and reverses to avoid damage. 2.
Overwork (Duty cycle: max 2 min on/10 min off) 1. Restart after suspending for 18 mins while connecting with power 2. Contact your supplier or dealer Not enough up & down height 1. Perform a reset operation 2. Contact your supplier or dealer Security advice 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
Waste disposal This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
