User Manual DA-70830 Package Contents: - 1 x USB 2.
Quick installation Follow these steps to quickly install your new USB 2.0 VGA Adapter: NOTE: Do not plug the USB 2.0 VGA adapter into the system before the driver is finished installing. 1. Insert the driver/manual CD and follow the instructions. 2. Make sure to restart the computer. 3. Turn on your 2nd monitor and connect it to the adapters. 4. Plug the adapter into an available USB 2.0 port. 5. After complete, you should see the extended display on the 2nd monitors.
USB-VGA (Primary) Make the USB 2.0 VGA Adapter the main display adapter in the system. The system’s main display adapter (and monitor) will automatically switch to being the secondary display adapter and act as the extended desktop. Note: Some display utility and drivers that ship with AGP and built-in display adapters will prevent this option from working on some systems.
USB-VGA (Off) This option disables the USB 2.0 VGA Adapter on the system. USB 2.0 VGA Adapter Properties To access the Display Properties for the USB 2.0 VGA Adapter, go to “Control Panel” and double click on the “Display” icon. Select the “Settings” tab. Click on the “Display” pull down menu and select the “USB 2.0 VGA DEVICE”. From here, you can change the resolution and color depth as desired. Click “OK” to apply the settings. You can also make these changes using the USB 2.0 VGA Adapter utility.
Virtual Repositioning Your Displays On the Settings tab of your Display Properties, click and drag the appropriate monitor icon (labeled 1 or 2) to the desired position. For example, the secondary display can be dragged to the left of the primary display, allowing it to be virtually on the left. Click OK or Apply to save the changes. Appendix --- Driver Installation Procedure step 1 : Execute the Setup.exe from the CD driver, and click “ Next “.
Step 2 : Click “ Next “. Step 3 : Select “Yes, I want to restart my computer now.” Click “ Finish “.
To make sure the “ USB 2.0 VGA” device has been installed successfully. Please move the cursor to “ Start ” Æ”Control Panel” Æ”Performance and Maintenance” Æ”System Properties” Æ”Hardware” Æ”Device Manager”. Then , please double click “Display adapters”, it will show 2 new directions. Î USB2.0 VGA DEVICE (DISPLAY) Î USB2.
Then , plug-in the USB-VGA adapter, please double click “Universal Serial Bus controllers”, it will show 1 new directions > ( USB2.0 VGA DEVICE (USB) UV icon for utility.
Frequently Asked Questions (FAQ) Q: Why can I not make the USB 2.0 to VGA Adapter the primary display? A: Some video cards ship their product with a utility that prevent other video cards from being set as the primary card. Check the bottom right hand corner taskbar for the utility. Disable the utility before switching our adapter to be the primary display.
Note: In the event of incorrect installation and improper use in a residential area, the device may cause disruptions in radio devices and other electronic devices. Proper use means that the device is operated with shielded connector cables as far as possible, for network products also with shielded cables of category 5e and higher. The device was tested and lies within the limits for computer accessories of class A according to the requirements of EN 55022. Warning ! This is a class A device.
