Datasheet
Table Of Contents
- Chapter 1 Read me first
- Chapter 2 Introduction
- Chapter 3 Package contents and parts description
- Chapter 4 About the assembling and setting of a hard disk
- Chapter 5 Connection with a PC and installation of a driver
- Chapter 6 Initialization and format the hard disk
- Chapter 7 How to use this product
- Chapter 8 Trouble Shooing
<important>
Please set of jumpers of Hard disk mode in the following way; HDD-1 is
Master, HDD-2 is Slave, HDD-3 is Master, HDD-4 is Slave, which like a
left-hand figure showing.
4. When Assemble the hard disk in the case, please mount HDD in the
order of HDD-1 → HDD-2 → HDD-3 → HDD-4.
5. Connect CN1 side of an IDE cable to “HDD-1” and “HDD-2” and
connect CN2 side (long one) to “HDD-3” and “HDD-4” and connect
each power supply connector.
#How to fix a hard disk with screws
Please take off the metal cover by removing three screws which are
allocated at rear side, and letting the cover off the case by sliding the
cover to the rear.
Slide the HDD to the position of Hard Disk screw hole which is near the
rear side of case(at the left picture), and then use the screw to fix it.
6. After the installation, please close the cover and the front panel.